Firstly, I'm new to blades from pizza boxes.
We just installed an m1000e with 6 x m600 blades.
I upgraded the cmc to 4.4. I was able to upgrade the idrac6 from 1.55 to 1.65. Unless I'm reading the support matrixes wrong, they show that idrac6 version 3.42 should be supported on the m600, but I cannot get it installed.
I tried upgrading idrac6 from 1.65 to 2.0 both through the cmc and idrac gui's using .imc file. - failed.
I tried upgrading the idrac6 from 1.65 to 3.42 both through the cmc and idrac gui's using .imc file - failed.
Please advise.
Mark